How do you remove and install ignition coils on a Buick Enclave,Chevrolet Traverse and GMC Acadia?

Disconnect the cable from the negative battery terminal. Remove the engine cover. On 2008 and earlier models, remove the underhood fuse/relay box to access the rear bank ignition coils. On 2009 and later models, remove the intake manifold to access the front bank ignition coils. Disconnect the electrical connector from coil. Remove the ignition coil mounting fastener. Pull up and twist to remove the coil. Apply a little silicone dielectric compound to the inside of each boot before installing it. Installation is the reverse of removal.

Genuine Buick Enclave Ignition Coil

Ignition Coil Resistor

Enter your vehicle info to find more parts and verify fitment

Select Vehicle by VIN
Select Vehicle by Model

Select by VIN

Enter your VIN for the most accurate results.

Select by Model

-- Select Make --

-- Select Model --

-- Select Year --

2 Ignition Coils found

View related parts
Buick Enclave Ignition Coil
Part Number: 12632479
- Other Name: Coil,Ignition
- Replaces: 12590990, 12618542, 12610626
$62.99 MSRP: $112.98
You Save: $49.99 (45%)

Add to Cart
More Info
Fits the following Vehicles:
2010-2021 Buick Enclave | BASE EXTENDED 4 DOOR SUV, PREMIUM 1 EXTENDED 4 DOOR SUV, PREMIUM 2 EXTENDED 4 DOOR SUV, SPORT UTILITY VEHICLE 2WD, SPORT UTILITY VEHICLE 4WD, SPORT UTILITY VEHICLE AWD | 6 Cyl 3.6L
2008 Buick Enclave | SPORT UTILITY VEHICLE 2WD, SPORT UTILITY VEHICLE AWD | 6 Cyl 3.6L
Less Info
View related parts
Buick Enclave COIL ASM,IGN
Part Number: 19418102
- Other Name: Ignition Coil, Spark Plug
- Replaces: 12613057, 12629037, 12583514
$87.11 MSRP: $183.02
You Save: $95.91 (53%)

Add to Cart
More Info
Fits the following Vehicles:
2009 Buick Enclave | SPORT UTILITY VEHICLE 2WD, SPORT UTILITY VEHICLE AWD | 6 Cyl 3.6L
Less Info

Buick Enclave Ignition Coil Parts Questions & Answers

COIL ASM,IGN
19418102
Q: How do you remove and install ignition coils on a Buick Enclave,Chevrolet Traverse and GMC Acadia?
A: Disconnect the cable from the negative battery terminal. Remove the engine cover. On 2008 and earlier models, remove the underhood fuse/relay box to access the rear bank ignition coils. On 2009 and later models, remove the intake manifold to access the front bank ignition coils. Disconnect the electrical connector from coil. Remove the ignition coil mounting fastener. Pull up and twist to remove the coil. Apply a little silicone dielectric compound to the inside of each boot before installing it. Installation is the reverse of removal.