×
My Garage
My Account
My Cart
Genuine Cadillac DTS Brake Light Switch
Brake Lamp SwitchEnter your vehicle info to find more parts and verify fitment
- Select Vehicle by VIN
- Select Vehicle by Model
Select by VIN
orEnter your VIN for the most accurate results.Enter your VIN for the most accurate results.
Select by Model
-- Select Make --
-- Select Model --
-- Select Year --
1 Brake Light Switch found
Cadillac DTS Sensor Assembly, Brake Pedal Position
Part Number: 20995840- Other Name: SENSOR, Brake; Clutch Switch, Position Sensor, Stoplamp Switch
- Replaces: 13348501, 92190131, 15223506, 25889337, 92220355
$15.69 MSRP: $29.60You Save: $13.91 (47%)
Cadillac DTS Brake Light Switch Parts Questions & Answers
- Q: How do you remove the brake switch in Cadillac DeVille,DTS and Seville?A: To remove the brake switch in vehicles from 2005 and earlier, start by removing the driver's side under-dash cover. Then, locate the switch at the top of the brake pedal bracket and twist it counterclockwise to remove it from the bracket. Disconnect the electrical connector from the switch. For installation, connect the electrical connectors to the switch and push the new switch into the clip until the switch plunger is fully depressed. Rotate the switch clockwise until it locks into position and no further adjustment is needed. Ensure that the brake lights are functioning properly. The rest of the installation process is the reverse of the removal. However, for vehicles from 2006 and later, a Brake Pedal Position (BPP) sensor is used, which requires a calibration procedure performed by a dealership service department or professional repair facility equipped for the necessary programming.
