Genuine GMC Jimmy Steering Knuckle

GMC Jimmy Steering Knuckle Parts Questions & Answers

• Steering Knuckle
  18060559
  Q: How do you remove the Steering Knuckle of 2WD Chevrolet Blazer,S10,GMC Jimmy and Sonoma?

  A: To remove the front suspension of a vehicle, start by raising the front of the vehicle and supporting it securely on jack stands. Apply the parking brake for safety. Then, support the lower Control Arm with a jack to compress the coil spring to its normal ride height. Remove the wheel and disconnect the ABS wheel speed sensor. Next, remove the brake caliper and the brake disc/hub assembly. If equipped, remove the disc splash shield. Disconnect the tie-rod end from the knuckle and disconnect the Ball Joints from the steering knuckle. Finally, remove the steering knuckle. To install the front suspension, simply reverse the removal steps. Make sure to adjust the front wheel bearings and have the front wheel alignment checked afterwards.
• Steering Knuckle
  18060559
  Q: How do you remove the Steering Knuckle of 4WD Chevrolet Blazer,S10,GMC Jimmy and Sonoma?

  A: To remove the drive axle/hub, put the vehicle in gear, apply the parking brake, and break loose the drive axle/hub nut with a socket. Use a puller to push the drive axle out while withdrawing the steering knuckle and hub assembly. To install the drive axle/hub, simply reverse the removal procedure, and lubricate the drive axle splines with multi-purpose grease.