Chevrolet 14064191 Belt, Special .380 "V" Cog

You can Select Your Vehicle to check if 14064191 fits your vehicle.

On L4 engines, the power steering pump belt should be removed if equipped. Then, the generator's adjusting and mounting bolts should be loosened, the generator should be moved toward the engine to loosen the belt, and a new belt should be installed over the pulleys. Adjust and tighten as necessary. Finally, if removed, the power steering pump belt should be reinstalled on L4 engines.

The air conditioning compressor is responsible for compressing and circulating refrigerant in the air conditioning system to cool the air inside the vehicle.

To inspect the drivebelts, open the hood with the engine off and locate them on the right side of the engine compartment. Check for cracks, separation, fraying, and glazing, which gives the belt a shiny appearance. Both sides of the belts should be inspected by twisting them to check the underside.

The water pump is driven by the same belts that drive the generator and power steering pump (when equipped), and is also connected to the A/C compressor belt.

The generator is a belt-driven component that is driven directly off of the crankshaft. Maintaining the proper tension on this belt is crucial to prevent excessive strain on the belt, as well as the generator's shafts and bearings. To check the tension of the belt, find the longest stretch and move it back and forth to gauge its slack. The distance it can be moved should be about ½-in (13 mm). If it moves more than this, the belt should be adjusted. Loosen the generator's adjusting and mounting bolts, move the generator away from the engine to adjust the belt, and then tighten the bolts. If the belt is frayed or cracked, it should be replaced. On L4 engines, remove the power steering pump belt if equipped. Loosen the generator's adjusting and mounting bolts, move the generator toward the engine to loosen the belt, and then install a new belt over the pulleys. Adjust and tighten as necessary. Finally, if removed, reinstall the power steering pump belt on L4 engines.

The tension of each drive belt can be checked by pushing on it at a distance halfway between the pulleys. The deflection of the belt should be within a specific range based on the distance between the pulleys.

The water pump is driven by the same belts that drive the generator and power steering pump (when equipped), and is also connected to the A/C compressor belt.

To adjust or replace any of these belts, the procedure described under the appropriate accessory is used.

The generator is driven directly off of the crankshaft through a belt.

To inspect the drivebelts, open the hood with the engine off and locate them on the right side of the engine compartment. Check for cracks, separation, fraying, and glazing, which gives the belt a shiny appearance. Both sides of the belts should be inspected by twisting them to check the underside.

If the belt moves more than the recommended amount, it needs to be adjusted. This can be done by loosening the compressor's adjusting bolts and mounting bolts, and moving the compressor away from the engine. Then, tighten the bolts and recheck the adjustment.

If adjustment is necessary, the belt-driven accessory can be moved on its bracket. A pry bar may be needed to provide leverage, but caution must be taken to avoid damaging the component or the part being pried against.

The air conditioning compressor is responsible for compressing and circulating refrigerant in the air conditioning system to cool the air inside the vehicle.