Chevrolet 22731231 Tank Assembly, Fuel

You can Select Your Vehicle to check if 22731231 fits your vehicle.

Raise the rear of the vehicle and support it securely on jackstands. Remove the rear section of the exhaust system and, if applicable, the driveshaft on AWD models.

Remove the fuel tank filler cap to relieve fuel tank pressure. Relieve the fuel system pressure. Disconnect the cable from the negative battery terminal. If the fuel tank is empty or nearly empty, it's not necessary to siphon the remaining fuel from the tank. But if there is a lot of fuel in the tank, obtain a siphon kit at an auto parts store and siphon out the remaining fuel. Raise the rear of the vehicle and support it securely on jackstands. Remove the rear section of the exhaust system. On AWD models, remove the driveshaft. Carefully clean around all of the vent hoses, squeeze the tabs and pull the connections apart. Disconnect the filler hose from the tank. The fuel tank fill hose uses a hose clamp-all other fittings are the quick-connect type. Also detach the fuel hose(s) at the fitting(s) near the tank, and the8/AP hoses from the canister. Disconnect the wiring harnesses from the fuel tank. Support the fuel tank securely. Remove the fuel tank retaining strap bolts and remove the straps. Carefully lower the fuel tank. If you're going to clean the fuel tank, do so. Installation is the reverse of removal. Be sure to tighten the fuel tank strap bolts securely. Reconnect the cable to the negative battery terminal, then start the engine and check for fuel leaks.

The fuel tanks installed in these vehicles are made of plastic and are not repairable.