Q: How to remove and install a door glass and regulator?
A: Lower the glass completely. Remove the door trim panel and the watershield. Remove the retaining screws, pull the door module back and disconnect the door lock and handle rods. Remove the electrical connector, if equipped. Remove the two glass run channel bolts and move the run channel away from the glass. Tilt the door module and window glass assembly and lower it out the bottom of the door. Bend the tab down on the window run channel to slide the door glass from the regulator assembly. For access to the power regulator components, drill out the rivets from the inside handle housing. On reassembly, use sheet metal screws in place of the rivets. Drill out the rivets from the regulator assembly and separate the regulator from the door module. On reassembly, use sheet metal screws in place of the rivets. Prior to installation, lubricate the window regulator mechanism with chassis grease. Installation of the glass and regulator is the reverse of removal.