Genuine Chevrolet Equinox Water Pump

Chevrolet Equinox Water Pump Parts Questions & Answers

• Engine Coolant Pump Kit
  12657499
  Q: How do you replace the water pump in a Chevrolet Equinox and GMC Terrain?

  A: To remove the condenser on 2007 and earlier models, unclip it. In 2010 and later models, the condenser must be completely removed. Inspect the radiator for leaks and damage, and if necessary, use special techniques for repair. Bugs and dirt can be removed from the radiator by spraying it with a garden hose nozzle from the back side, and it should be flushed out with a garden hose before installation. For installation, guide the condenser/radiator/fan assembly into position, ensuring that the rubber mounts on the bottom are properly seated into the support. Tighten the radiator and air conditioning condenser bracket bolts securely. Fill the cooling system with the proper mixture of antifreeze and water, start the engine, and check for leaks. Allow the engine to reach normal operating temperature, then recheck the coolant level and add more if required. Finally, check the transaxle fluid and add more as needed.
• Water Pump Assembly
  12630084
  Q: What are the signs and consequences of a failure in the water pump on Chevrolet Equinox and GMC Terrain?

  A: A failure in the water pump can lead to serious engine damage as it causes overheating. These models have a water pump that is driven by the drivebelt. Water pumps are typically equipped with weep or vent holes, which can leak coolant if there is a failure in the pump seal. To check for leaks, a flashlight and small mirror can be used to locate the hole on the water pump. If the water pump shaft bearings fail, there may be a howling sound while the pump is running, and shaft wear can be felt by rocking the water pump pulley up and down with the drivebelt removed. It is important not to mistake drivebelt slippage, which causes a squealing sound, for water pump bearing failure. Even if a pump shows no outward signs of a problem, such as noise or leakage, it may still need to be replaced. The only sure way to determine this is through removal for close examination. A quick check of water pump performance is to turn on the heater. If the pump is failing, it may not be able to efficiently circulate hot water to the Heater Core as it should.