Where is the brake light switch located and how do you remove and adjust it?

The location of the brake light switch is in a bracket positioned at the top of the brake pedal. When you press on the pedal, it turns on rear brake lights in your car. In order to take it off, one has to disconnect wiring harness and negative battery cable. After that, unscrew the switch from a pedal bracket while turned locknut loose. For installation purposes, people only need to do things inversely with what they did during its removal. To adjust this unit, just set 1/32-3/64 inch gap between threaded portion and pedal stop then locknut firmly. Finally, connect wires and battery again and check whether back lights are functioning well or not.

Genuine Chevrolet Metro Brake Light Switch

Brake Lamp Switch

Enter your vehicle info to find more parts and verify fitment

Select Vehicle by VIN
Select Vehicle by Model

Select by VIN

Enter your VIN for the most accurate results.

Select by Model

-- Select Make --

-- Select Model --

-- Select Year --

2 Brake Light Switches found

View related parts
Chevrolet Metro Switch,Stop Lamp
Part Number: 30014186
- Other Name: SWITCH, Stop Lamp Switch; Brake Switch, Clutch Switch, Stoplamp Switch
More Info
Fits the following Vehicles:
1995-2000 Chevrolet Metro | 2 DOOR, 4 DOOR | 3 Cyl 1.0L, 4 Cyl 1.3L
1989-1991 Chevrolet Metro | 2 DOOR, 4 DOOR, LSI 2 DOOR, LSI 4 DOOR, LSI CONVERTIBLE | 3 Cyl 1.0L
Less Info
View related parts
Chevrolet Metro Switch Asm,Stop Lamp (On Esn)
Part Number: 91176999
- Other Name: SWITCH, Stop Lamp Switch; Stoplamp Switch
- Replaces: 30012789, 88924685
More Info
Fits the following Vehicles:
1990-2001 Chevrolet Metro | 2 DOOR, 4 DOOR, CONVERTIBLE, LSI 2 DOOR, LSI 4 DOOR, LSI CONVERTIBLE, XFI 2 DOOR | 3 Cyl 1.0L, 4 Cyl 1.3L
Less Info

Chevrolet Metro Brake Light Switch Parts Questions & Answers

Switch Asm,Stop Lamp (On Esn)
91176999
Q: Where is the brake light switch located and how do you remove and adjust it?
A: The location of the brake light switch is in a bracket positioned at the top of the brake pedal. When you press on the pedal, it turns on rear brake lights in your car. In order to take it off, one has to disconnect wiring harness and negative battery cable. After that, unscrew the switch from a pedal bracket while turned locknut loose. For installation purposes, people only need to do things inversely with what they did during its removal. To adjust this unit, just set 1/32-3/64 inch gap between threaded portion and pedal stop then locknut firmly. Finally, connect wires and battery again and check whether back lights are functioning well or not.