Where is the CMP sensor located?

The CMP sensor is located on the right (passenger) end of the rear cylinder head. Disconnect the cable from the negative battery terminal. Disconnect the CMP sensor electrical connector. To remove the CMP sensor, unplug the electrical connector and remove the sensor retaining bolt. Remove the CMP sensor retaining bolt and remove the CMP sensor. Remove and inspect the CMP sensor 0-ring for wear or damage. If it's worn or damaged, replace it. Coat the new 0-ring with clean engine oil, then install it on the CMP sensor. Installation is the reverse of removal. Tighten the CMP sensor retaining bolt to the specific torque.

Genuine Cadillac Deville Camshaft Position Sensor

Cam Position Sensor

Enter your vehicle info to find more parts and verify fitment

Select Vehicle by VIN
Select Vehicle by Model

Select by VIN

Enter your VIN for the most accurate results.

Select by Model

-- Select Make --

-- Select Model --

-- Select Year --

2 Camshaft Position Sensors found

View related parts
Cadillac Deville Sensor Assembly, Camshaft Position <Use 12F 37
Part Number: 12575483
- Other Name: SENSOR, Distributor (also Knock Sensor); Camshaft Position Sensor, Camshaft Sensor
- Replaces: 10456628
$81.78 MSRP: $169.82
You Save: $88.04 (52%)

Add to Cart
More Info
Fits the following Vehicles:
2000-2005 Cadillac Deville | DEVILLE, FUNERAL COACH, HIGH LUXURY, LIMOUSINE, SEVILLE, SLS, STS, TOURING 4 DOOR, TOURING SEDAN | 8 Cyl 4.6L
Less Info
View related parts
Cadillac Deville Sensor,Camshaft Position
Part Number: 10456041
- Other Name: SENSOR, Distributor (also Knock Sensor); Camshaft Position Sensor
More Info
Fits the following Vehicles:
1994-1999 Cadillac Deville | 4 DOOR, DEVILLE, SLS, STS | 8 Cyl 4.6L
Less Info

Cadillac Deville Camshaft Position Sensor Parts Questions & Answers

Sensor Assembly, Camshaft Position <Use 12F 37
12575483
Q: Where is the CMP sensor located?
A: The CMP sensor is located on the right (passenger) end of the rear cylinder head. Disconnect the cable from the negative battery terminal. Disconnect the CMP sensor electrical connector. To remove the CMP sensor, unplug the electrical connector and remove the sensor retaining bolt. Remove the CMP sensor retaining bolt and remove the CMP sensor. Remove and inspect the CMP sensor 0-ring for wear or damage. If it's worn or damaged, replace it. Coat the new 0-ring with clean engine oil, then install it on the CMP sensor. Installation is the reverse of removal. Tighten the CMP sensor retaining bolt to the specific torque.