With the window glass fully up, remove the door trim panel and water shield. For the outside handle, pry the remote rod out of the handle with a small screwdriver, remove the nuts, and lift the handle off after pushing the outside handle rod clip off. Installation is the reverse of removal. For the inside handle, disconnect the rod from the handle, punch out the center pins of the rivets securing the
Window Regulator, and drill the rivets out with a 3/16-inch drill bit. Lift the handle from the door, then place the handle in position for installation and secure it to the door using 3/16-inch rivets and a rivet tool. The remainder of installation follows the reverse of removal.