when replacing the side view mirror then one has to uninstall the door trim panel then also has to take out the mirror fastener access plug from the door. Then, as the final action, take out the mirror mounting nuts and the mirror and release the electrical connector of the mirror. Disassembly, in this case, is as follows: the installation process is the reverse process of the removal process described above. While handling the mirror glass, always put on safety glasses and gloves since the glass cannot be handled without breaking. To demount the glass from the motor, use a flat-blade screwdriver or a plastic trim tool; if the mirrors are electric, remove the electrical connectors. Screw the wires to the new mirror glass and insert it on the motor section. For the inside mirror, the sensor cover clips can be released in order to pull the cover and its electrical connector out, while the mirror can be either removed or installed by unscrewing a Torx screw or a set screw at the base on the windshield. If the mount plate has been removed from the windshield there are adhesive kits available in auto parts stores for reattaching the mount plate and the procedure in the instructions should be followed.