First of all, to untangle the cable from the negative terminal of the battery is needed. Using a piece of plastic trim tool you should lift and prise the upper cover up at both ends, where it was attached to the lower cover. When this is the case pull up on the front edge of the trim cover to unlock the rear hooks and reveal the upper bolts of the lower column cover. Before the upper column cover is pulled apart from the flexible trim, the instrument cluster bezel must be taken out; the two retaining clips on the sides of the instrument cluster must firstly be pried up with a screwdriver before the upper column cover is then pulled apart from the flexible trim. For top of lower trim cover, first, take off the upper trim cover and then take out the upper screws of the lower trim cover, in this position, may turn the steering wheel for better access at this stage. Then, it is necessary to turn under the lower cover fastener and take off the trim cover with the steering column, if necessary, the steering wheel height control lever is released. Last among these is Installation; this is simply the process of removing being done in the reverse.