To replace the latch, first raise the window completely and remove the door trim panel along with the rear section of the watershield. Detach the latch rods from the lock cylinder, outside handle, and inside handle, working through the opening in the door. Remove the three Torx-head mounting screws, which may require an impact-type driver to loosen, and then take the latch out of the door. If possible, disconnect the rods while the latch is still in place; otherwise, pull the latch out with the rods attached, then disconnect the rods and electrical connectors. For installation, reverse the removal procedure and ensure the door latches and unlatches properly. To remove the lock cylinder, first take off the outside door handle and disconnect the link. The lock cylinder is secured with either two bolts or a retainer; if it has a retainer, use a screwdriver to push it off. After removing the lock from the door handle, installation follows the reverse of removal. For the outside handle, disconnect the links from the handle and the lock cylinder rod, remove the mounting bolts, and detach the handle from the door. Reposition the handle, attach the link, and install the nut(s), tightening them securely. To remove the inside handle, first take off the door trim panel, then slide the handle rearward to detach it from the holes and remove it from the door, allowing for the disconnection of the two cables. For minor door adjustments regarding latch alignment, loosen the bolts on the latch striker mounted opposite the latch, move the striker slightly as needed, and then retighten the bolts while checking for proper latch operation; the striker can be adjusted up-and-down or left-and-right.