Genuine GMC Yukon Rack and Pinion Boot

GMC Yukon Rack and Pinion Boot Parts Questions & Answers

• Boot,Steering Gear (Spool Shaft)
  26048003
  Q: How to remove and install steering rack boots on Chevrolet Avalanche,Silverado,Suburban,Tahoe,GMC Sierra,Yukon,Yukon Denali and Yukon XL?

  A: To remove and install rack and pinion boots, loosen the wheel lug nuts, raise the front of the vehicle, and support it securely on jackstands. Remove the tie-rod ends and the locknuts. Remove the outer boot clamps with pliers, cut off the inner boot clamps, and throw them away. Mark the location of the breather tube in relation to the rack and pinion assembly, then remove the boots and the tube. Apply grease to the exposed ends of the toothed rack before installing new boots. To install new boots, install a new clamp on the inner end of the boot. Apply grease to the groove on the tie-rod and the mounting grooves on the rack and pinion. Line up the breather tube with the marks made during removal (if applicable) and slide the new boot onto the rack and pinion housing. Make sure the boot isn't twisted, then tighten the new inner clamp. Install the outer clamps and tie-rod end locknuts. Finally, install the tie-rod ends and have the front-end alignment checked and, if necessary, adjusted.