Chevrolet 84143517 Rear Lower Suspension Control Arm Assembly

You can Select Your Vehicle to check if 84143517 fits your vehicle.

After installing the control arm, you should have the front wheel alignment checked and adjusted if necessary.

To remove the upper trailing arm, start by loosening the wheel lug nuts and raising the vehicle on jackstands. Support it securely and block the front wheels. Remove the wheel and detach the ABS wheel speed sensor harness clips from the trailing arm. Use a floor jack to support the lower control arm and remove the upper trailing arm-to-knuckle nut and bolt. Make an alignment mark on the upper trailing arm adjuster cam to the subframe. Hold the adjuster cam bolt with a wrench and unscrew the nut. Remove the nut and cam, then remove the pivot bolt. Finally, remove the upper trailing arm from the knuckle and subframe. For installation, raise the lower control arm to simulate normal ride height and align the marks on the adjuster cam and subframe. Tighten the inner and outer fasteners to the proper torque specifications. Install the wheel, lower the vehicle, and tighten the lug nuts. Have the wheel alignment checked and adjusted if necessary. To remove the lower trailing arm, remove the coil spring and the trailing arm-to-subframe pivot bolts. For installation, raise the outer end of the trailing arm with a floor jack to simulate normal ride height. Install the wheel, lower the vehicle, and tighten the lug nuts. For the adjuster link, remove the rear shock absorber and the adjuster link-to-knuckle nut. Make an alignment mark on the adjuster link adjuster cam to the subframe. Hold the adjuster cam bolt with a wrench and unscrew the nut. Remove the nut and cam, then remove the pivot bolt. Remove the adjuster link from the knuckle and subframe. For installation, raise the outer end of the lower trailing arm with a floor jack to simulate normal ride height. Install the wheel, lower the vehicle, and tighten the lug nuts. Have the wheel alignment checked and adjusted if necessary. To remove the upper trailing arm-to-lower trailing arm link, support the lower trailing arm with a floor jack and remove the upper trailing arm-to-knuckle bolt. Remove the link-to-knuckle bolt and detach the link. For installation, raise the outer end of the trailing arm with a floor jack to simulate normal ride height. Install the wheel, lower the vehicle, and tighten the lug nuts. Have the wheel alignment checked and adjusted if necessary.