GM 84514420 Switch Assembly, T/Sig *Jet Black

To replace the head light, dimmer and fog light switch, one has to first remove the cable from the negative terminal of the battery. Furthermore, with the help of a trim tool, remove switch from the driver's side switch panel and pull the connectors off the switch. Perform the same steps for heads-up display HUD switch-remove the battery cable, pull the HUD switch assembly out from the passenger's side switch panel, and sever the electrical connectors. For the hazard flasher switch it is part of the radio/heater/ air conditioner control module and must be removed and replaced as an assembly, the following procedure is followed; the center trim radio, and heater/air control panel is to be removed, the radio control assembly is then removed from the trim panel for testing before reinstalling all the parts in the reverse order it was removed.

Disconnect the cable from the negative terminal of the battery. Remove the instrument cluster trim panel and the steering column covers. For the windshield wiper switch, depress the locking tabs on the top and bottom of the wiper switch and remove it from the switch housing, disconnecting the electrical connector(s) before releasing the tabs and pulling the switches out; installation is the reverse of removal. For the turn signal switch and driver information center switch, depress the locking tabs on the top and bottom of the turn switch and remove it from the switch housing by depressing the retaining tabs and sliding the switch out; installation is the reverse of removal.

On 2015 and earlier models/2016 Malibu Limited, remove the driver's knee bolster. Reach up behind the headlight switch, push in on the tabs on either side while applying slight pressure, then push the switch assembly out the front of the dash. For 2016 and later models (except Malibu Limited), remove the left instrument panel outer trim cover by prying it off with a trim tool, and for 2015 and later models (except Malibu Limited), pry off the left-side instrument panel trim panel with a plastic trim tool. With the switch removed, disconnect the electrical connection. Installation is the reverse of removal.

In order to remove the multi-function switch the first step is to pull the lilt wheel lever and lower the steering wheel. Subsequently, the two steering column trim covers are to be detached and the electrical connection to the multi-function switch is to be disconnected. The retaining tabs of the switch have to be pressed and then the switch has to be pulled out of the mounting bracket. Removing the switch mounting bracket requires the removal of the steering wheel covers, the steering wheel and the clockspring can be disconnected from the mounting bracket during the removal. Any electrical connections, and or wire harness brackets that may be connected to the mounting bracket should be removed. For models from 2015 and earlier (and 2016 Malibu Limited)-two bolts fixing a mounting bracket to the steering column should be removed. On 2016 and later models (excluding Malibu Limited), It is necessary to release the locking tabs on both sides. Pull the steering column down and move the mounting bracket off it and in case of the clockspring, release the three square-shaped tabs and remove it from the mounting bracket. Last of all, installation can also be done in the reverse order of removal.