Idle speed adjustment must be carried out after the engine has fully warmed up, with the air cleaner fitted unless specified otherwise, and it is essential for the ignition timing and dwell angle to be correctly set, along with all emission control systems functioning properly. To check engine speed, an external tachometer must be connected according to the manufacturer's instructions. If the information on the Emissions label differs from the Specifications, the label should be considered correct. Disconnect the electrical lead from the idle speed solenoid if equipped, and adjust the base idle speed screw to the rpm specified on the emission label, ensuring the shift selector on automatic transmissions is in Drive and manual transmissions are in Neutral. The idle mixture screws are preset at the factory and sealed, requiring adjustment only in cases of major carburetor overhaul, throttle body replacement, or high emissions readings during official inspections. Since the mixture screws are sealed, an artificial enrichment procedure using propane gas is necessary to check the mixture, as adjusting by other means may violate the law.