Genuine Buick Regal A/C Accumulator

Buick Regal A/C Accumulator Parts Questions & Answers

• Accumulator,Evap Dehyd
  2724240
  Q: How to remove and install an Accumulator Assembly?

  A: The sealed accumulator assembly is connected to the evaporator outlet pipe and functions as a liquid/vapor separator that receives refrigerant vapor, some liquid refrigerant and refrigerant oil from the evaporator. It contains a desiccant which acts as a drying agent for the moisture that may have entered the system. To remove the accumulator, disconnect the negative Battery Cable, properly discharge the air conditioning system into a recovery/recycling machine, remove the air cleaner and resonator assemblies, disconnect the low-pressure lines at the inlet and outlet fittings on the accumulator, unplug the pressure cycling switch connection and remove the switch, loosen the lower strap bolt and spread the strap, turn the accumulator and remove. Drain and measure the oil in the accumulator, discard the old oil, add new oil equivalent to the amount drained from the old accumulator plus an additional 2-3 oz. (60-90ml) of oil to compensate for the oil retained by the accumulator desiccant, position the accumulator in the securing bracket, tighten the clamp bolt to 88 inch lbs. (10 Nm), install new O-rings at the inlet and outlet connections on the accumulator, lubricate the O-rings with refrigerant oil, connect the low-pressure inlet and outlet lines, tighten to 35 ft. lbs. (48 Nm), connect the negative battery cable, tighten the cable bolt to 11 ft. lbs. (15 Nm), evacuate, charge and leak test the system, reinstall the air cleaner assembly if removed, reset the radio, clock and any other applicable electronic devices.