×
My Garage
My Account
My Cart
Genuine Cadillac DTS Rack and Pinion Boot
Enter your vehicle info to find more parts and verify fitment
- Select Vehicle by VIN
- Select Vehicle by Model
Select by VIN
orEnter your VIN for the most accurate results.Enter your VIN for the most accurate results.
Select by Model
-- Select Make --
-- Select Model --
-- Select Year --
1 Rack and Pinion Boot found
Cadillac DTS Boot Kit,Steering Gear
Part Number: 21011025- Other Name: BOOT KIT, Steering Tie Rod; Boot, Boot Kit, Inner Tie Rod Boot, Tie Rod Boot
Cadillac DTS Rack and Pinion Boot Parts Questions & Answers
- Q: How do you replace Rack and Pinion Boot on Cadillac DeVille and DTS?A: To remove the tie-rod ends, start by cutting off the inner boot clamp and discarding it. Use pliers to squeeze the tangs and slide the outer boot clamp off the boot. Then, detach the boot from the vent cross tube (if equipped) and slide the boots off the tie-rod. Before installing the new boots, wrap the threads on the ends of the tie-rods with a layer of tape to protect the small ends of the new boots during installation. To install the new boots, loosely install the inner boot clamp on each boot and slide them onto the tie-rod, securing them on the Rack And Pinion. Connect the breather tube, if applicable. Use boot clamp pliers to tighten the inner boot clamp and slide the outer clamp onto the boot. Finally, install the tie-rod ends and connect them to the Steering Knuckle. It is important to have the front-end alignment checked and adjusted if necessary.
