Genuine Cadillac DTS Vehicle Speed Sensor

VSS

Enter your vehicle info to find more parts and verify fitment

  • Select Vehicle by VIN
  • Select Vehicle by Model
Select by VIN
Enter your VIN for the most accurate results.
Enter your VIN for the most accurate results.
or
Select by Model
-- Select Make --
-- Select Model --
-- Select Year --

3 Vehicle Speed Sensors found

  • Cadillac DTS Vehicle Speed Sensor - 24207491
    View related parts

    Cadillac DTS Sensor Assembly, Automatic Transmission Input Speed

    Part Number: 24207491
    • Other Name: SENSOR, Speedometer Drive
    • Replaces: 24206074
    $83.40 MSRP: $165.46
    You Save: $82.06 (50%)
    Add to Cart
    More Info
    Fits the following Vehicles:
    • 2006-2011 Cadillac DTS | 4 DOOR, FUNERAL COACH, LIMOUSINE | 8 Cyl 4.6L
    Less Info
  • Cadillac DTS Vehicle Speed Sensor - 24204319
    View related parts

    Cadillac DTS Sensor Assembly, Vehicle Speed

    Part Number: 24204319
    • Other Name: SENSOR, Speedometer Drive; Vehicle Speed Sensor
    $20.92 MSRP: $39.48
    You Save: $18.56 (48%)
    Add to Cart
    More Info
    Fits the following Vehicles:
    • 2006-2011 Cadillac DTS | 4 DOOR, FUNERAL COACH, LIMOUSINE | 8 Cyl 4.6L
    Less Info
  • Cadillac DTS Vehicle Speed Sensor - 4676095
    View related parts

    Cadillac DTS Sensor Assembly, Vehicle Speed

    Part Number: 4676095
    • Other Name: SENSOR, Electronic Brake Control; Rear Speed Sensor
    More Info
    Fits the following Vehicles:
    • 2006-2011 Cadillac DTS | 4 DOOR | 8 Cyl 4.6L
    Less Info

Cadillac DTS Vehicle Speed Sensor Parts Questions & Answers

  • Q: Where is the Vehicle Speed Sensor (VSS) located?
    A: The VSS (Vehicle Speed Sensor) is located on top of the transaxle. Remove cable from NEGATIVE BATTERY CABLE. Lift the vehicle and secure it with jackstands. Disconnect the VSS connector. To remove the VSS, unplug the electrical connector and remove the VSS retaining bolt. Remove Retaining Bolt for VSS. Pull out the VSS straight up to get it out of the transaxle opening where it is located. Take off and throw away the old 0-ring. Apply a little clean motor oil to new 0-ring, then install it on VSS. The specific torque at which to tighten the retaining bolt is given here, so fix that bolt accordingly during installation of this module itself. Reconnect a VSS electrical connector back in place where you removed one before. Now lower vehicle, and reconnect NEGATIVE BATTERY CABLE again.

Related Cadillac DTS Parts