How to remove and install a starter solenoid for Chevrolet Astro?

The battery's negative terminal cable should be disconnected. The starter motor must be removed. Disconnect the strap from the solenoid which mates with the starter motor terminal. Remove the two screws that hold down solenoid to the starter motor. Turn it manually in clockwise direction and disengage flange from starter body. Remove screws mounting solenoid to frame, then turn it clockwise while pulling for removal off-starter motor of a starter solenoid. To put it back, make sure return spring is on plunger, then place solenoid body in housing of a starter and finally engage flange by turning solenoid counterclockwise. Get two screws for the solenoid in addition to connecting motor strap.

Genuine Chevrolet Astro Starter Solenoid

Starter Solenoid Relay

Enter your vehicle info to find more parts and verify fitment

Select Vehicle by VIN
Select Vehicle by Model

Select by VIN

Enter your VIN for the most accurate results.

Select by Model

-- Select Make --

-- Select Model --

-- Select Year --

2 Starter Solenoids found

View related parts
Chevrolet Astro Switch,Starter Solenoid
Part Number: 1114591
- Other Name: SWITCH, Starter Motor; Solenoid, Starter Solenoid
- Replaces: 1114578
More Info
Fits the following Vehicles:
1991-1996 Chevrolet Astro | VAN ASTRO | 6 Cyl 4.3L
Less Info
View related parts
Chevrolet Astro Switch,Starter Solenoid
Part Number: 1114531
- Other Name: SWITCH, Starter Motor; Drive, Solenoid, Starter Solenoid
More Info
Fits the following Vehicles:
1985-1990 Chevrolet Astro | VAN ASTRO | 4 Cyl 2.5L, 6 Cyl 4.3L
Less Info

Chevrolet Astro Starter Solenoid Parts Questions & Answers

Switch,Starter Solenoid
1114591
Q: How to remove and install a starter solenoid for Chevrolet Astro?
A: The battery's negative terminal cable should be disconnected. The Starter motor must be removed. Disconnect the strap from the solenoid which mates with the starter motor terminal. Remove the two screws that hold down solenoid to the starter motor. Turn it manually in clockwise direction and disengage flange from starter body. Remove screws mounting solenoid to frame, then turn it clockwise while pulling for removal off-starter motor of a starter solenoid. To put it back, make sure return spring is on plunger, then place solenoid body in housing of a starter and finally engage flange by turning solenoid counterclockwise. Get two screws for the solenoid in addition to connecting motor strap.