My Garage
My Account
Cart
Genuine Chevrolet C1500 Throttle Cable
Accelerator Throttle Cable- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
9 Throttle Cables found
Chevrolet C1500 Throttle Cable
The Chevrolet C1500 Throttle Cable provides a direct mechanical connection between the throttle body and the accelerator, which enables the driver to control engine airflow with a simple press on the accelerator. The Throttle Cable, which is braided and made of metal, connects the pedal to the butterfly valve shaft. When the pedal is pressed, the plate opens wider. The powertrain control module then adds more air and more fuel, providing smooth power. In the past, Chevrolet pickups applied this simple system alone as it was cost-effective, well-known, and free of electronic delay. In those classic C1500 years, the driver felt an immediate response because the Throttle Cable translated motion without sensors or motors. Nonetheless, later Chevrolet models implemented electronic throttle control with the introduction of new technology as the Throttle Cable was replaced with pedal position sensors for traction and idle management and an electric throttle actuator, all of which eliminated the steel link. The original Throttle Cable supplies a firm, linear pedal feel while the newer drive-by-wire setup relies on software to interpret the driver's intent. This is the difference that a C1500 owner will feel on an early and late model truck.
Each OEM Chevrolet C1500 Throttle Cable we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Chevrolet C1500 Throttle Cable Parts Questions & Experts Answers
- Q: How to replace the throttle cable on these transmissions on Chevrolet C1500?A:The throttle cable used on these transmissions should not be thought of as a "downshift" cable. The throttle cable controls line pressure, shift feel, shift points, detent downshifts and part throttle downshifts. The function of the cable is similar to the combined functions of a detent cable and a vacuum modulator. To replace it, first remove the air cleaner. Then, detach the cable terminal (end) from the throttle lever by pulling it forward, off the mounting lug. Compress the locking tangs on the cable housing and detach the housing from the bracket by pinching the locking tangs of the throttle cable housing with a pair of pliers and pushing the housing through the bracket. Remove the routing clips or straps. Trace the cable to the transmission and remove the bolt and the flat washer. Pull up on the cable cover at the transmission until the cable is visible, then disconnect the cable from the transmission link. Remove the seal. Installation is the reverse of removal. Be sure to tighten the bolt securely. When you're finished reattaching the throttle cable assembly, adjust it. With the engine off, depress and hold down the metal re-adjust tab at the engine end of the throttle cable. Move the slider until it stops against the fitting. Release the re-adjust tab. Rotate the throttle lever to its full travel position. The slider must move (ratchet) toward the lever when the lever is rotated to its full travel position. Make sure the cable moves freely. The cable may appear to function properly with the engine stopped and cold. Recheck it after the engine is hot. Finally, road test the vehicle.
