In order to remove the multi-function switch the first step is to pull the lilt wheel lever and lower the steering wheel. Subsequently, the two steering column trim covers are to be detached and the electrical connection to the multi-function switch is to be disconnected. The retaining tabs of the switch have to be pressed and then the switch has to be pulled out of the mounting bracket. Removing the switch mounting bracket requires the removal of the steering wheel covers, the steering wheel and the clockspring can be disconnected from the mounting bracket during the removal. Any electrical connections, and or wire harness brackets that may be connected to the mounting bracket should be removed. For models from 2015 and earlier (and 2016 Malibu Limited)-two bolts fixing a mounting bracket to the steering column should be removed. On 2016 and later models (excluding Malibu Limited), It is necessary to release the locking tabs on both sides. Pull the steering column down and move the mounting bracket off it and in case of the clockspring, release the three square-shaped tabs and remove it from the mounting bracket. Last of all, installation can also be done in the reverse order of removal.