Genuine Chevrolet Suburban Fuel Pump

Chevrolet Suburban Fuel Pump Parts Questions & Answers

• Fuel Tank Fuel Pump Module Kit
  19332070
  Q: How to replace and install the fuel pump/fuel level sending unit on Chevrolet Avalanche,Silverado,Suburban,Tahoe,GMC Sierra,Yukon,Yukon Denali and Yukon XL?

  A: Place the removed fuel pump/fuel level sensor on a clean surface. Disconnect the sensor's electrical connector and wiring harness. Remove the fuel level sensor from the pump module. If any component is defective, replace the entire module. To reinstall, slide the sensor into place until it clicks and verify its position. Follow the removal steps in reverse for installation.
• Fuel Tank Fuel Pump Module KIT (W/O Fuel Lvl Sen)
  19368772
  Q: How to check the operation of the fuel pump?

  A: To check the fuel pump, sit in the vehicle with windows closed and turn ignition key to ON. Listen for pump sound as it pressurizes fuel system. If no sound, remove fuel filler cap and have assistant turn ignition switch to ON while you listen. Check fuse, relay, wiring, and replace pump if necessary. Connect fuel pressure gauge to test port on fuel feed line and start engine. Compare gauge reading to specifications. If pressure is low, check filter, lines, and hoses for issues. Replace fuel pump module if regulator is stuck open.
• Fuel Tank Fuel Pump Module Kit (Acdelco Only)
  19208962
  Q: How to remove the fuel pump/fuel level sending unit module on Chevrolet Avalanche,Silverado,Suburban,Tahoe,GMC Sierra,Yukon,Yukon Denali and Yukon XL?

  A: At first, disconnect the cable from the negative side of the battery and release the pressure in the fuel system so that you can remove the fuel pump/fuel level sensor. Remove the fuel tank, then disconnect both evaporative (EVAP) vent line and fuel tank vent line fitting as well as two quick-connect fittings on the fuel supply line from the mounting flange of the fuel pump/fuel level sensor. With water pump pliers, rotate off a lock ring of a fuel pump/fuel level sensor using care not to damage a float arm and a float of a fuel level. After checking o-ring it may be necessary to replace one before installing a new pump. During installation, align these marks made on this flange with those on a tank and carefully put down this flange into their seats where my float arm or even floats will neither be harmed nor damaged when they are placed until they reach there at all.