To replace the outside mirrors, first, one needs to take out the door trim panel, and the door insulator. After that, one has to remove the mirror wiring harness from the door and then remove the connector. Take the nuts off and unscrew the mirror from the door, making sure to pull out the electical connector is it is a power model. To uninstall an L10 splitter, reverse the installation process that is described above. In the same case with the outside mirror, one may turn the electrical connector if it is present, then undo the setscrew and slide the mirror off the support base on the windshield. Reinstallation is done in the opposite way to uninstallation, that is from top to bottom. If the support base is released from the windshield one can put it back using the mirror adhesive kit which is available in the auto parts stores; wash clean both the surface of the glass and the support base, apply the adhesive in the manner described in the package inserting and the support base should be allowed to set for a day before fixing the mirror.