Genuine Saturn Vue Sway Bar Kit

Saturn Vue Sway Bar Kit Parts Questions & Answers

• Shaft, Rear Stabilizer
  21990361
  Q: How do you remove the rear stabilizer bar and stabilizer bar bushing for Saturn Vue?

  A: To remove the sway bar kit, start by raising the rear of the vehicle and supporting it securely on jack stands. Then, disconnect the sway bar kit links from the rear, using a Torx or Allen wrench if necessary. Next, unbolt the sway bar bushing retainers and remove the retainer brackets from the body if needed.
• Shaft, Front Stabilizer
  22624756
  Q: How do you remove the front stabilizer bar and stabilizer bar bushing?

  A: To remove the sway bar bushing kit, start by loosening the front wheel lug nuts and raising the front of the vehicle with jack stands. Remove the front wheels and, on four-cylinder models, the front section of the exhaust pipe. Disconnect the sway bar bushing kit links from the bar, making sure to hold the ball stud with a Torx or Allen wrench if it turns with the nut. Disconnect the left Tie Rod End from the Steering Knuckle and detach both sway bar bushing kit retainers from the subframe. Slide the sway bar bushing kit out of the left wheel well and inspect the retainer bushings for any cracks, wear, or deterioration. Clean the bushing area of the sway bar bushing kit with a stiff wire brush to remove any rust or dirt. To install the sway bar bushing kit, lubricate the inside and outside of the new bushing with vegetable oil for easier reassembly. Install the links, tightening the link nuts to the specified torque. Install the retainers and bolts, tightening them to the specified torque. Finally, install the wheels and lug nuts, lower the vehicle, and tighten the lug nuts to the specified torque.