Chevrolet 39149294 Switch Assembly, T/Sig *Jet Black

Disconnect the cable from the negative terminal of the battery, then remove the steering column covers. Next, disconnect the electrical connectors, depress the locking tabs, and remove either of the two switches from the steering column. Installation is the reverse of removal.

In order to remove the headlight switch assembly, one has to open the left side storage compartment or fuse access panel door, stick hand through the slots and pull the switch backwards from the instrument panel. Unplug it by pulling the Locking Tab and simultaneously pressing on the Retainer of the circuit connector. The accessory bezel switches include the hazard flasher, door lock, and the passenger's airbag indicator; to gain access to these, the accessory bezel trim panel has to be unscrewed or unbolted. Pull out the electrical connectors from the switches, unscrew the mounting screws and let the switches be taken from the back side of the accessory trim panel. As for the power outlet, use a small screwdriver and pull the outlets up and out of the center console from where it can be disconnected from its electrical connector. The center console switch panel is removed by pulling the trim panel as well as disconnecting the electrical connector. Remove the retaining tabs with a small screwdriver and remove the switch from the rear side of the panel. The backside of the panel has a slot, where you should insert the switch panel, then reattach the connector. The remaining installation steps as are given below are the reverse of the removal process.