GM 19210707 Pad Kit,Rear Disc Brake

You can Select Your Vehicle to check if 19210707 fits your vehicle.

The initial steps to remove and replace brake pads on a vehicle are as follows: Loosen the lug nuts. Raise the vehicle on jackstands. Remove the wheels. Inspect the brake disc.

To remove and replace brake pads, first loosen the lug nuts and raise the vehicle on jackstands. Remove the wheels and inspect the brake disc. Use a C-clamp to depress the pistons into the caliper bores. Remove the caliper mounting bracket bolts and detach the caliper and brake pads from the steering knuckle, being sure to hang the caliper with a length of wire. Remove the outer brake pad, separate the mounting bracket from the caliper, and remove the pad retainers from the bracket. Install new retainers and remove the inner brake pad from the caliper. Remove the caliper guide pin seals and boots and install new ones, then remove the upper guide pin from the mounting bracket and install a new one. To install new brake pads, lubricate the guide pins of the caliper mounting bracket with high-temperature brake grease and install the bracket to the caliper. Install new pad retainers to the mounting bracket, then install the new inner and outer pads. Finally, install the caliper/bracket/brake pad assembly over the disc and install the caliper mounting bracket bolts, tightening them to the torque specifications.

Before installing new brake pads, follow these steps:Remove the caliper guide pin seals and boots. Install new seals and boots. Remove the upper guide pin from the mounting bracket and install a new one.

Before installing new brake pads, follow these steps: Remove the caliper guide pin seals and boots. Install new seals and boots. Remove the upper guide pin from the mounting bracket and install a new one.