Make sure this part fits

Oldsmobile 22048583 Antenna, Electric (W/Tube)

1982-1988 Oldsmobile Cutlass

Customer Questions & Expert Answers (6)
GM 22048583 Antenna, Electric (W/Tube)
  • Part Description
    ANTENNA, Power Radio Antenna
  • Manufacturer
    General Motors
  • Manufacturer's Notes
    This part is discontinued.
Make sure this part fits
  • Related Parts
  • Product Specifications
  • Vehicle Fitment
  • Customer Questions & Expert Answers
  • Product Specifications

    BrandGenuine Oldsmobile
    Manufacturer Part Number22048583
    Part DescriptionANTENNA, Power Radio Antenna
    Other NamesAntenna, Antenna Assembly, Mast, Power Antenna
    Item Dimensions18.5 x 3.4 x 2.7 inches
    Item Weight1.20 Pounds
    ConditionNew
    Fitment TypeDirect Replacement
    ManufacturerGeneral Motors
    SKU22048583
    WarrantyThis genuine GM part is guaranteed by GM's factory warranty.
    Shipping & ReturnShipping Policy Return Policy
    Warning: California's Proposition 65
  • Vehicle Fitment

    Year Make Model Engine Important vehicle option details
    1982-1988 Oldsmobile Cutlass4 Cyl 2.5L, 6 Cyl 2.8L, 6 Cyl 3.0L, 6 Cyl 3.8L, 6 Cyl 4.3L Diesel, 8 Cyl 4.3L, 8 Cyl 5.0L, 8 Cyl 5.7L Diesel2 DOOR, 4 DOOR, BROUGHAM 2 DOOR, BROUGHAM 4 DOOR, CUTLASS CALAIS, CUTLASS CRUISER
  • Customer Questions & Expert Answers

    Q:
    I would like to confirm if this is the correct part number for my vehicle. Please advise. Thank you. Posted by GMPartsGiant Specialist
    A:
    You can Select Your Vehicle to check if 22048583 fits your vehicle.
    Posted by GMPartsGiant Specialist
    Q:
    How to replace a manual antenna on Buick Regal? Posted by Customer
    A:
    Begin by removing the antenna cable from the radio under the dashboard and replace it. Then unscrew the fender to take off the antenna, which is still attached with its wire, from the car. For new antenna installation, insert the cable lead into the wheel well of the fender and route it toward the radio so that it connects with its back. The screw is used to fix in place an antenna mast on a fender such as this one and to verify its operation. Next, take out the mast from its base and remove trimming part off antenna housing. Undo housing mounting screws at first, then take out lead-in cable of the antenna through engine compartment routing. Remove antennae base assembly and put on new base assembly routing lead-in cable towards radio. Tighten mounting screws for housing of antennae through screwing them up. Install trim for antennae housing then attach antennae to base. Take negative battery cable off then remove instrument panel sound absorber pad in order to install power antennae inside fender. Disconnect relay assembly's antena lead-in and harness connector from them. Use masking tape at rear edge of door and fender if required. Remove inner to outer fender retaining screws as well as front wheel assembly when necessary too. In some cases, take away lower rocker panel and inner splash shield from fender as needed also. Before removing antennae upper retaining nut, unbolt it from bracket along with thirteen other nuts that hold bracket for fitting antennae to vehicle body on passenger side front fender where they removed though here is no picture showing any detail concerning these steps or their exact position; what was shown however was only a general diagram without important information like how many bolts could be on each joint between parts mentioned above except mentioning either side or about another bolt being below there between both brackets since nothing else had been mentioned regarding any other part used besides nuts & Bolts used so far except few specific ones which were mentioned briefly at first. Put it into position, then loosely install power antennae to bracket retaining bolts and upper antenna retaining nut. Finally, reverse the installation procedure and apply silicone grease to the harness connector before reconnecting the negative battery cable. Lastly, test the antennae mast and restore normal functioning of any affected accessory.
    Posted by GMPartsGiant Specialist
    Q:
    Is there anything else that needs to be removed of the 1985 Buick Regal? Posted by Customer
    A:
    Remove the inner splash shield from the fender, as required.
    Posted by GMPartsGiant Specialist
    See expert answers on similar Antenna
    Q:
    What is the first step before accessing the power antenna motor for the 1982 Chevrolet El Camino? Posted by Customer
    A:
    Disconnect the negative battery cable.
    Posted by GMPartsGiant Specialist
    See expert answers on similar Antenna
    Q:
    What is the procedure for installation of the antenna assembly for the 1983 Pontiac Firebird? Posted by Customer
    A:
    For installation, reverse the removal steps, ensuring the mast is fully retracted and the lower bracket is secured by the fender skirt retaining screw.
    Posted by GMPartsGiant Specialist
    See expert answers on similar Antenna
    Q:
    How do you remove the antenna and motor assembly of the 1983 Oldsmobile Cutlass? Posted by Customer
    A:
    Remove the antenna and motor assembly through the fender skirt opening.
    Posted by GMPartsGiant Specialist
    See expert answers on similar Antenna
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

Genuine GM Part 22048583, the Right Choice

To ensure reliability, purchase GM part # 22048583 Antenna, Electric (W/Tube). It is sometimes referred to as Oldsmobile Antenna. Directly from GM, genuine parts are superb with regards to quality, longevity, and fit. Every single part passed stringent quality testing, so you can be sure that it's safe, durable, and built to perform like your original parts. This part fits specific Oldsmobile Cutlass models.

GMPartsGiant.com is a leading supplier of genuine GM parts and accessories such as GM 22048583 Antenna, Electric (W/Tube). You're certainly in the right place if you're searching for the great cost-effective OEM GM parts. Look no further than our vast inventory of genuine GM parts offered at unbeatable online prices, all of which are backed by the manufacturer's warranty. Not to forget, our hassle-free return policy and quick delivery service ensure a smooth shopping experience for you. For detailed Oldsmobile parts information, click here.

Why choose GM Parts Giant

  • Dedicated Service

    Your complete satisfaction is our #1 goal

  • Lowest Prices

    Best deals on genuine OE parts from dealerships

  • Fast Delivery

    Orders are processed and delivered promptly