Pontiac 15214346 Blade, Windshield Wiper

The windshield wiper and blade assembly entails the wiper arm and the blade that wipe the windshield and should be checked periodically for indications of damage in the frame, loosened components, presence of cracked or worn units in the blade parts. Since the wiper blades are used to clean the road film on the windshield, they must be kept clean so as to be effective in their work; this can be done by washing them with mild detergent solution. The working of the wiping mechanism can cause loose bolts, nuts, and fasteners that should be tightened whenever one is checking on the wiper blades. If the elements of the wiper blade are in bad shape which includes being cracked, WORN or warped the new ones should be fitted. In early models pull on the wiper blade while inserting a thin screwdriver to engage the release lever and then disengage the spring. Once the blade has been slid off, then the rubber element can be pulled out with the fingers, with the help of a metal backing or a retaining clip. After determining the length of the new element as well as its design, the user can then position the new element and then it will snap to the correct position, since the position will already be locked. Place the blade back on to the arm, dampen the windshield glass and try the proper functioning of the blade. For the subsequent models, its dismantling involves pulling the wiper blade off the windshield, press a button, and sliding the whole blade in the wiper's hook and gently placing the wiper on the windshield. The rubber wiper is fitted at one end of the blade element channel; pull the locking feature on the element to clear the tangs on the claw of assembly channel and remove the element from the frame. In some models, there may be some specific rubber element which is not available separately, and this will entail replacing the whole blade. This is simply the opposite of the removal process, checking whether the rubber element and the blade assembly are well anchored before wiping the windshield glass then checking if the wiper works as required.

The windshield wiper and blade assembly needs to be checked on regular basis for any sort of damages, loose speedy and ravaged or frayed blade elements. Dirt can gather on the wiper blades and reduce the quality of the road film so it should be washed with a mild detergent solution. If the wiper blade elements of the wand will have cracks, wear, twists or do not clean sufficiently, they will add further ones. To replace the wiper blade assembly, one has to pull up the arm assembly so that it is out of contact with the glass, press upwards on the release lever and sliding the wiper blade assembly out of the hook positioned at the end of the arm. Subsequently, connect the new wiper to the arm and make certain that it stays in place because you will hear a click.

Periodically check the windshield wiper blade component for breaks and wear. Lift the wiper blade assembly off the glass. Squeeze both the release tabs of the wiper blade together and rotate outwards, unhooking the blade from its arm. Compare new blades to old ones for length, design, etc. Reverse all of this to install a new blade. Make sure that you properly fasten your wiper blade, then wet your windscreen in order to test for proper operation.

The windshield wiper blade elements should be checked periodically for cracks and deterioration. To begin, lift the wiper blade assembly away from the glass. Next, press the release lever and slide the blade assembly out of the hook at the end of the wiper arm. Squeeze the two rubber prongs at the end of the blade element to slide it out of the frame, noting that these elements can be replaced by hand without the need for pliers. Compare the new element with the old one for length and design, as some replacement elements may feature a three-piece design held together by small plastic sleeves; keep the sleeves in place until you start sliding the element into the frame, removing them as needed. Slide the new element into the frame with the notched end last, securing the clips into the notches. Finally, reinstall the blade assembly on the arm, wet the windshield, and test for proper operation.

The windshield wiper blade elements.

This is one wiper blade per order

Yes, this is the k-hook wiper blade