Pontiac 88861353 Fuse,10 A (Ato Fuse)

The vehicle's electrical circuits are covered by a mixture of fuses, circuit breakers and fusible links. The fuse block can be seen beneath the instrument panel on the left side of dashboard. Every one fuse covers a particular circuit and these circuits are indicated on the fuse itself. The miniature fuses are used in the fuse block with blade terminal design for fast removal and installation with fingers. Always check if the fuse has blown whenever an electrical component fails to work properly. A test light is the best method of checking fuses. You should see whether each fuse has power at its exposed terminal tips or not. When there is power on one side of the fuse but none on the other, it means that this device is blown out. This can also be visually observed when it happens to occur. Remember that broken fuses have to be replaced using correct types only. Fuses will physically fit into any rated slot; however, you must use only those which suit specific ratings accordingly! It's not recommended replacing a higher or lower value than specified fuse thereon! Each electrical circuit requires some amount of protection against overloads or short circuits caused by damaged wiring or components which fail due to age or accident.

When an electrical component fails, you can check the fuse with a test light by checking for power at the exposed terminal tips of each fuse.

When removed, a blown fuse is easily identified through the clear plastic body. Visually inspect the element for evidence of damage.

The main fuse/relay panel is located in the engine compartment, while the interior fuse/relay panel is inside the passenger compartment.

The various circuits are identified on the fuse panel itself.

It is important to replace blown fuses with the correct type because fuses of different ratings may be physically interchangeable, but only those of the proper rating should be used to ensure adequate protection for each electrical circuit.

Blown fuses should be replaced with the correct type and rating.

If a replacement fuse fails immediately, the underlying issue, often a short circuit due to damaged wiring, should be addressed before further replacements.

Each fuse is designed to protect a specific circuit, which can be identified on the fuse panel.

The electrical circuits of a vehicle are protected by a combination of fuses, circuit breakers, and fusible links.

Each fuse is designed to protect a specific circuit, with the various circuits identified on the fuse panel itself.