This procedure applies only to 231 cu in V6 engines. Manual transmission flywheels are balanced at the factory, and no attempt should be made to balance them. The automatic transmission flex plate can be balanced using balance clips available from the dealer parts department. If the flex plate is found to be out of balance, raise the car and remove the lower flex plate cover, marking the flex plate at four locations 90 degrees apart. Install a clip at one of the marked locations, and with the transmission in 'Neutral', run the engine to note any vibration. If the vibration increases, remove the clip and relocate it 180 degrees from its original location. If the vibration decreases, install another clip next to the original one. If no change is noted in the vibration, move the clip 90 degrees and run the engine again. Repeat this procedure until a reduction in vibration is noted, making fine adjustments by moving the clips in small increments until the vibration is eliminated. Ensure that the tangs on the clips are properly set in the flex plate to prevent shifting at high speeds.