XT4 | 2019-2023 | All Purpose 4 Door Luxury, ALL PURPOSE 4 DOOR LUXURY, All Purpose 4 Door Sport, ALL PURPOSE 4 DOOR SPORT | 4 Cyl 2.0L, 4 Cyl 2.0L Diesel
Other Name: Bulb,Headlamp ; Seal Beam; Capsule, Headlamp, Sealed Beam
Fits the following Cadillac Models:
Escalade | 1999-2000 | 1 TON CREW CAB, 1/2 TON, 3/4 TON, 4 DOOR 1/2 TON, CLASSIC 4 DOOR 1/2 TON, CREW CAB 1 TON, EXTENDED CAB 1 TON, EXTENDED CAB 6'6" BOX 1/2 TON, EXTENDED CAB 6'6" BOX 3/4 TON, EXTENDED CAB 8' BOX 3/4 TON, K2500 CREW CAB, K3500 CAB CHASSIS 135.5, K3500 CAB CHASSIS 159.9, REGULAR CAB 1 TON, REGULAR CAB 3/4 TON, YUKON/DENALI/ESCALADE | 8 Cyl 5.7L
| Page 1 of 20 |Next >
1-20 of 388 Results
Cadillac Headlight
For superior quality and affordable Cadillac Headlights, consider our website. We proudly present a wide selection of genuine Cadillac Headlights at unbeatable prices. These OEM parts, supported by the manufacturer's warranty, are also eligible for our hassle-free return policy and swift delivery service.
Cadillac Headlight Parts Questions & Experts Answers
A: The headlight adjustment screw controls the up-and-down movement of the headlights, while left-and-right movement is not adjustable. To adjust the headlights, a blank wall 25 feet in front of the vehicle and a level floor are needed. Position masking tape on the wall in alignment with the vehicle centerline and the centerlines of both headlights. Measure the height of the headlight reference marks from the ground and place a horizontal tape line on the wall at the same height. It may be easier to position the tape with the vehicle parked just a few inches away. Ensure the vehicle is sitting level, with the gas tank half-full and no unusually heavy load. Turn on the low beams and adjust the screw to position the high intensity zone two inches below the horizontal line. It is advisable to have the headlights adjusted by a dealer service department at the earliest opportunity.
Q: How to remove and install headlight assemblies on Cadillac DeVille?
A: Take off the radiator cover frame. Loosen the bolts/nuts holding the headlight, then pull the headlight assembly straight away to release its retaining clip for later versions. To get at the bulb(s) or connecter, take out the housing and undo the headlight bolts. Remove the housing from the vehicle. Installation is the reverse of removal.
Q: How to remove and install Headlight housing on Cadillac Escalade?
A: In headlamp lens refurbishing, there is need to detract the radiator grille as well as the front bumper upper fascia. Second, unscrew the four headlight housing bolts with attention to the headlamp housing screw locations in both front and side views. With some delicacy pry up the headlight housing and you can see that there are two locator pins located at the edges of the housing. When fixing this housing, these pins should line with their respective holes in the front fender bracket, below. Installation is otherwise the reverse of removal, up to the point of tightening of nuts and bolts, among others. The last setting is the headlights, after installation is complete.