How do you remove the A/C Condenser?

To remove the air conditioning system, start by discharging the system and disconnecting the battery cable. Then, disconnect the refrigerant line fittings from the condenser and cap them to prevent dirt and moisture from entering. Remove the upper radiator shroud and radiator, as well as the screws holding the vertical plastic panels and upper insulator brackets. Finally, pull the condenser out of the vehicle. For installation, reverse the removal steps and use new R-134a-compatible o-rings on the refrigerant line fittings. If a new condenser is installed, add 1 oz. of new refrigerant oil. After installation, have the system evacuated, recharged, and leak tested.

Genuine Chevrolet S10 A/C Condenser

Air Conditioning Condenser

Enter your vehicle info to find more parts and verify fitment

Select Vehicle by VIN
Select Vehicle by Model

Select by VIN

Enter your VIN for the most accurate results.

Select by Model

-- Select Make --

-- Select Model --

-- Select Year --

1 A/C Condenser found

View related parts
Chevrolet S10 Condenser,A/C
Part Number: 52482105
- Other Name: CONDENSER, A/C Condenser; Condenser
- Replaces: 52479563, 52450235, 52457306
More Info
Fits the following Vehicles:
1982-1994 Chevrolet S10 | 2 DOOR, 4 DOOR, PICKUP | 4 Cyl 1.9L, 4 Cyl 2.0L, 4 Cyl 2.2L, 4 Cyl 2.2L Diesel, 4 Cyl 2.5L, 6 Cyl 2.8L, 6 Cyl 4.3L
Less Info

Chevrolet S10 A/C Condenser Parts Questions & Answers

Condenser,A/C
52482105
Q: How do you remove the A/C Condenser?
A: To remove the air conditioning system, start by discharging the system and disconnecting the battery cable. Then, disconnect the refrigerant line fittings from the condenser and cap them to prevent dirt and moisture from entering. Remove the upper Radiator shroud and radiator, as well as the screws holding the vertical plastic panels and upper insulator brackets. Finally, pull the condenser out of the vehicle. For installation, reverse the removal steps and use new R-134a-compatible o-rings on the refrigerant line fittings. If a new condenser is installed, add 1 oz. of new refrigerant oil. After installation, have the system evacuated, recharged, and leak tested.