2006-2010 Pontiac G6 | GT 2 DOOR CONVERTIBLE, GT 2 DOOR NOTCHBACK, GT 4 DOOR NOTCHBACK, GTP 2 DOOR CONVERTIBL, GTP 2 DOOR NOTCHBACK, GXP 2 DOOR NOTCHBACK, GXP 4 DOOR NOTCHBACK, SE 4 DOOR NOTCHBACK, SE1 2 DOOR NOTCHBACK, SE1 4 DOOR NOTCHBACK | 4 Cyl 2.4L
2005-2010 Pontiac G6 | GT 2 DOOR CONVERTIBLE, GT 2 DOOR NOTCHBACK, GT 4 DOOR NOTCHBACK, GTP 2 DOOR CONVERTIBL, GTP 2 DOOR NOTCHBACK, GXP 2 DOOR NOTCHBACK, GXP 4 DOOR NOTCHBACK, SE 4 DOOR NOTCHBACK, SE1 2 DOOR NOTCHBACK, SE1 4 DOOR NOTCHBACK | 6 Cyl 3.5L, 6 Cyl 3.5L Flex, 6 Cyl 3.9L
Less Info
Pontiac G6 Ignition Coil Parts Questions & Answers
Q: How to remove and install ignition coils in Pontiac G6?
A: Four-cylinder and 3.6L V6 models (Coil-on-plug type) Begin with pulling off the wire from the negative battery terminal, and then remove any engine covers. In case of working on No. 5 cylinder of a 3.6L models, avert EVAP canister purge tube. Next, unplug all electrical connectors to the coils. To take out an ignition coil from either four-cylinder or a three-point-six-liter V6 model, detach the electric connector and undo coll fastening boll afterwards hold coll tightly while removing it in upward direction. After that, just pull them out firmly grasping them after taking off mounting bolts for coils too. Assembly is done by doing everything backward when disassembling. 3.5L AND 3.9L V6 MODELS (COIL PACK TYPE) First, disconnect the cable from the negative battery terminal; on Models with 3.liters of capacity, remove engine cover and unplug MAP sensor; thereafter do same to coil pack electrical connector; label each spark plug wire set apart next take coil pack away; spray some dielectric silicone lubricant inside each spark plug boot before sliding them over coil pack nipples; reverse removal is otherwise installation process would end up as.