Q: How to disconnect and install a release cylinder on a clutch housing?
A: Disconnect the cable from the negative terminal of the battery. Raise the vehicle and support it securely on jackstands. Disconnect the hydraulic line at the slave cylinder. If available, use a flare-nut wrench on the fitting, which will prevent the fitting from being rounded off. Have a small can and rags handy, as some fluid will be spilled as the line is removed. Remove the slave cylinder mounting bolts. Remove the slave cylinder. Install the slave cylinder on the clutch housing. Make sure the pushrod is seated in the release fork pocket. Connect the hydraulic line to the slave cylinder. Tighten the connection securely. Fill the brake master cylinder with the proper brake fluid. Bleed the system. Lower the vehicle and connect the negative battery cable.