You will have to first switch the ignition key to OFF for four-cylinder models and unhook the cable from the negative battery terminal. Next, you have to lift up the front of the vehicle and hold it firmly with jackstands. You should remove both the
Battery Cable and starter control cable from their respective terminals on the starter motor solenoid. After that, undo some starter motor mounting bolts in order to take out a starter motor. To reinstall, follow these reverse steps while tightening mounting bolts to specified torque values. For V6 models, begin by turning ignition key to OFF and disconnecting cable from negative battery terminal as well. Loose right front wheel lug nuts and raise front of vehicle onto jackstands.Then, take out right front wheel and disconnect battery cable and starter control cable from starter motor solenoid terminals.Remove wiring harness clip from engine block by pushing aside till you can get at starter motor.Dismount lower start motor bolt-do not forget about lowering vehicle.Removing upper start motor bolt which enables one to pull off engine.To reinstall, follow these reverse steps while tightening mounting bolts to specified torque values.