My Garage
My Account
Cart
Genuine Saturn Vue Door Lock Cylinder
Door Lock Cylinder Tumbler- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
3 Door Lock Cylinders found
Saturn Vue Lift Gate Lock Cylinder Assembly
Part Number: 15841210$60.11 MSRP: $86.38You Save: $26.27 (31%)
Saturn Vue Door Lock Cylinder
Saturn Vue Door Lock Cylinder is a major part of the vehicle situated in the front doors where the operation of locking and unlocking of the doors of the car is controlled by the use of the car key. This mechanism plays a vital role in actuating and locking the vehicle to create an environment for the occupant and can also grant entry into the cabin of the car. The Saturn Vue Door Lock Cylinder may become worn out after sometime of usage hence have operational complications for example a key that cannot turn or stuck in the Cylinder. Although many of the contemporary automobiles have shifted from the conventional door lock cylinders, the Saturn Vue has retained the part and if signs of failure are observed, then replacement becomes inevitable. It is important to make sure that the Door Lock Cylinder will be able to perform correctly to provide security to the vehicle and at the same time allowing easy access to it. Maintaining it or replacing it on time to avoid some problems arising from an exhausted Door Lock Cylinder in Saturn Vue models.
Each OEM Saturn Vue Door Lock Cylinder we offer is competitively priced and comes with the assurance of the manufacturer's warranty for the part. Furthermore, we guarantee the speedy delivery of your orders right to your doorstep. Our hassle-free return policy is also in place for your peace of mind.
Saturn Vue Door Lock Cylinder Parts Questions & Experts Answers
- Q: How to Remove and Replace a Door Handle, Door Latch Assembly and Door Lock Cylinder on Saturn Vue?A:To avoid cutting oneself on metal edges when working inside the door openings wear gloves. Regarding the door latch, first pump up the window then take out the door trim panel and the watershield. Pull the rods through the large access hole turning their plastic lips off and pulling them out of the clips to disengage the rods form the handle and lock cylinder. Pull out the electrical connectors at the latch, then unlock the inside handle rod and the lock rod from their respective tracks, the latch plate screws are then unscrewed from the door. Remove the latch assembly in which the inside handle rod together with the lock rod remains connected, then remove these two rods from the latch assembly. For the outside handle, to open it, pulling the handle, the pin at the bottom must be removed and then, moving the handle forwards, it will be unlocked. To replace the lock cylinder of the door, follow the procedure of raising the window, then, unplugging the outer door panel, pulling out the retaining clip situated at the rear part of the lock cylinder and pushing the lock into the door again, before releasing the lock rod from the latch then taking out the lock cylinder. To install, make sure that the lock is well fixed at the outer door panel and fix the retaining clip. To take off inside door handle, unscrew the screw on the cup of handle trim at the centre, pull out the handle toward the exterior and forward while removing the handle from the door panel, then you have to pull off both rods from the latch and, if there is any, cut off the wiring harness at the back side of the handle. For all components, installation is the same as removal in reverse.
