Cadillac 15841240 Shaft, Front Stabilizer

Start by loosening the nut fasteners on both front wheels then raise the vehicle front section before securely supporting it on jackstands. Apply your parking brake followed by blocking your rear wheels with jackstands in place then remove the front wheels. Before removing the sway bar links from struts or control arms, record the bushing and washer placement that connects the links to control arms. Begin by removing the sway bar bracket bolts then angle the right-side steering knuckle left before sliding the bar onto it before pulling until clearance from the frame occurs. Check the bushings for signs of damage as well as wear before initiating replacement procedures. To install the sway bar, place it within its required position followed by loose attachment of bushings and clamps then carefully aim the bar at the vehicle center before connecting the sway bar to its links before tightening fasteners to the designated torque values. To finish the installation, first put the wheels on the vehicle then lower it to the ground and tighten all the lug nuts according to the specified torque value.

Follow the reverse of the removal steps and tighten the fasteners to the specified torque.