GM 10383794 Manual Transmission Shift Lever Cable Assembly

You can Select Your Vehicle to check if 10383794 fits your vehicle.

To remove the shift cable, first disconnect it at the transaxle and test the shifter to see if it moves smoothly without the cable. If adjustment is needed, follow these steps: 1. Raise the front of the vehicle and secure it on jackstands. 2. Remove the nut securing the cable near the exhaust manifold. 3. Lower the vehicle. 4. Remove the center console and push aside the driver's side carpet for access to the cable grommet. 5. Pry the shift cable end from the shift lever pin using a flat-blade screwdriver. 6. Pry the U-shaped shift cable retaining clip away from the cable. 7. Place a blanket over the driver's fender. 8. Locate the shift lever in the engine compartment and disconnect the cable end from it. 9. Squeeze the clip on the shift cable and pull it up from its bracket. 10. Pry the large rubber cable grommet from the firewall. 11. Carefully remove the shift cable by pulling it through the hole in the firewall from the engine compartment side.

Snap down the locking tabs at the front of the shifter to secure the cables.

To install the shift cable, follow the reverse steps of the removal process. Ensure the cable is properly snapped into place onto the levers.

Pull back the carpeting and pull the cables through the grommet in the floor pan.