GM 10055040 Front Bumper Cover

First to loose the front bumper fascia you need to unbolt the sidemarker light and also unlock the bulb holder located into the light assembly. Furthermore, the two screws from each sidemarker light assembly indent holding the front bumper fascia to the front fender panel are next, then the three screws from each inner fender panel holding the fascia to the inner fender panel. Then, turn to the seven screws which fasten the fascia to the body front end assembly, and to three push retainers which are located underneath the car on the grille area. Following that, you have to unfasten the front bumper fascia and popclr out the central portion of each push retainer by drilling it with 1/4-inch before dislodging the energy absorber. New energy absorber enable you to securely fasten the push retainers and the front bumper fascia together through the seven mounting screws destined for the body front end assembly-to be tightened merely to the extent to which they can be tightened using only fingers. Put the three push retainers under the lower face, next screw in the three mounting screws to each inner fender panel, do not over tighten at this point. Third, fit the two mounting screws for the front bumper fascia into front fender panel to each sidemarker light assembly indent as a fingertip twist. Ensure that the posted fascia sits and aligns well with the front compartment lid before aligning and tightening all posted mounting screws. Last of all turn in the bulb holder and fix the sidemarker light assembly in its position.

Both the front and rear bumper face bars are made of urethane, which can endure minor impacts and revert to its original shape.

Disconnect all four bulb holders from the backside of each taillight lens by pushing in the locking tabs and turning the bulb holders counterclockwise. For the inboard three bulb holders, push in the lock tab and rotate counterclockwise, while for the outboard bulb holder, rotate counterclockwise and pull it out.