Other Name: Fascia,Rear Bumper Upper (Primed Assembly); Bumper Cover
Position: Rear Upper
Replaces: 12335673, 12335974
Fits the following Pontiac Models:
Grand Prix | 2004-2008 | 4 DOOR, GT 4 DOOR, GT2 4 DOOR, GTP 4 DOOR, GXP 4 DOOR | 6 Cyl 3.8L, 8 Cyl 5.3L
| Page 1 of 12 |Next >
1-20 of 236 Results
Pontiac Bumper
If you're searching for OEM Pontiac Bumpers, look no further. Our website boasts an extensive inventory of genuine Pontiac Bumpers, all available at competitive prices online. Every part we offer comes with a manufacturer's warranty. In addition, we provide a straightforward return policy and rapid delivery services, making your shopping experience a breeze.
Q: How to remove and install the front bumper on Pontiac Fiero?
A: First to loose the front bumper fascia you need to unbolt the sidemarker light and also unlock the bulb holder located into the light assembly. Furthermore, the two screws from each sidemarker light assembly indent holding the front bumper fascia to the front fender panel are next, then the three screws from each inner fender panel holding the fascia to the inner fender panel. Then, turn to the seven screws which fasten the fascia to the body front end assembly, and to three push retainers which are located underneath the car on the grille area. Following that, you have to unfasten the front bumper fascia and popclr out the central portion of each push retainer by drilling it with 1/4-inch before dislodging the energy absorber. New energy absorber enable you to securely fasten the push retainers and the front bumper fascia together through the seven mounting screws destined for the body front end assembly-to be tightened merely to the extent to which they can be tightened using only fingers. Put the three push retainers under the lower face, next screw in the three mounting screws to each inner fender panel, do not over tighten at this point. Third, fit the two mounting screws for the front bumper fascia into front fender panel to each sidemarker light assembly indent as a fingertip twist. Ensure that the posted fascia sits and aligns well with the front compartment lid before aligning and tightening all posted mounting screws. Last of all turn in the bulb holder and fix the sidemarker light assembly in its position.