Disconnect the shift cables from the bracket on the side of the transaxle by pulling and discarding the retaining clips. Use two screwdrivers to evenly pry the cable ends from the balls on the transaxle levers, taking care to avoid forcing the ends to one side. Disconnect the cables from the clip on the steering gear and from the shifter assembly. Remove the cover from the right side of the console, then pull the carpet back from the area where the cable passes through the firewall. Pull the cable grommet out of the firewall and remove the cables. Installation is the reverse of removal; replace the clips that were discarded and ensure the grommet seats properly in the firewall.