Cadillac 52498883 Motor Kit,Blower (W/ Impeller)

The blower motor position differs between various trim levels and model years because vehicles having either front/rear climate controls need alternate installation than vehicles with limited front control only. The necessary steps to work on the engine compartment blower motor include disconnecting the negative battery cable and removing the cowl cross-tower brace before cutting through the rubber insulator and taking out the metal patch plate. Start by detaching power connections from the blower motor followed by disconnecting its cooling hose and screws which will allow you to disengage the motor from its case. Installation requires creating a 25 mm space between spark plug wires and the HVAC blower motor before installing the blower motor fan assembly followed by reconnecting electrical components as well as cooling hose and mounting screws and restoring the cowl cross-tower brace before reconnecting the battery cable. Begin passenger compartment repairs by taking off the negative battery cable followed by right-hand instrument panel insulator removal and extinguishing the blower motor electrical connector. Start by taking the bolts or screws loose from the blower motor cover after removing the right-hand body hinge pillar trim panel. Support the blower motor during the last bolt removal process and take out the isolator from the blower motor flange if needed. You should install the blower motor service kit first and then position the isolator before aligning the motor under the proper position using bolts or screws for installation. The battery cable should be installed after reattaching the electrical connector and instrument panel insulator and replacing the trim panel. Before starting work on Eldorado and Seville vehicles operators must disconnect the negative battery cable followed by removal of the cowl cross-tower brace and relay center bracket and detachment of the wiring connector and cooling tube until all blower motor mounting screws are removed. To replace the fan first tilt the blower motor and then install the fan inside the case before securing the blower motor with screws under which you will reconnect the cooling hose and the wiring connector followed by reinstallation of relay center and bracket nuts.