To replace a sealed beam headlight, put off the headlight switch, and for the earlier models, take out the headlight bezel. Subsequently, unscrew the headlight retaining ring screws, do not touch the adjusting screws and lift off the headlight retaining ring. Re wire the headlight electrical connector and pull out the headlight. Removing is done in reverse to installation while adjusting the headlights takes place. To work on a halogen bulb-type headlight, power off the headlight switch first; for the side lens, you have to unbolt the headlight's side lens retaining bolt situated at the car's fender and pull it out. After that, there is removal of three mounting screws in order to liberate the headlight assembly from the core support so as to disconnect bulb electrical connections as well as the grasping of the bulb holder where it will be turned anti-clockwise to be released. Removal is done in the reverse order of installation; the headlights may be adjusted if needed.